Deep Drawing and Stamping Oils: Lubrication in Sheet Metal Forming
In sheet forming, lubrication decides tearing, scratching and die wear. Selection by operation severity and removability.
In deep drawing, stamping and press operations, the sheet slides on the die surface under high pressure. Without the right lubrication: tearing, thinning, scratching, build-up on the die and early die wear occur. The forming oil is chosen by operation severity.
Operation severity decides
- —Light (simple bending, shallow draw): Low-viscosity, easy-to-clean oils or dry film.
- —Medium (drawing, stamping): High-load-carrying, EP-additive drawing oils.
- —Heavy (deep drawing, stainless/thick sheet): High-EP, high-film-strength products, sometimes with solid lubricants.
Critical properties
- —Film strength / EP: Prevents metal-to-metal contact under high pressure and stops tearing.
- —Coating uniformity: An even film; a dry spot means scratches and tears.
- —Removability: If the part will be painted/welded, the oil must clean off easily; otherwise extra cost.
- —Corrosion protection: No rust in interim storage after forming.
Application method
Roller, spray, dip or drip — the method sets the film amount and uniformity. Too little oil scratches, too much wastes and raises cleaning cost. Automatic lubrication improves consistency.
Material difference
Galvanised, stainless, aluminium and thick carbon sheet each need different oil; choose formulas that do not damage the galvanised coating, high EP for stainless, and non-staining for aluminium.
Summary
Lubrication in sheet forming is a balance of operation severity + film strength + removability. The right oil reduces scrap and die wear. Ahmet Ceviz recommends the drawing/stamping oil that fits your sheet and operation; test it with a sample.
